Mmm!! Bendage

Yikes.
IMO, this is the problem with a tower to tower brace.
Excessive reinforcement down the middle just pushes the weak point(s) to the outer edges of the tower.
Think Arrma should have used a stronger material for the towers.
It's crazy to me how much these bend, and the lengths people go through to reinforce the area.
Brace or no brace...this is weak area of the truck.
You gonna pound it out, or buy a replacement?

Maybe 3 support rods would help, shock to shock? And center.

@J.Ramos undoubtedly yes.
That is a lot of support for an area of the truck that should be more adequately reinforced than it comes OOTB.

Engineer in me says, rectangular / square alliminum for weight. Supports and stabalizes center to shock impact distribution.

@Camo, Just curious, How big of a hit did the truck take to cause this? Nose dive off a big jump?

Nothing wrong with the banana rear tower...Lol. Probably won't bend any further. So long as rear shocks aren't getting torqued, shouldn't cause any issues. Better than tweaking your chassis and blowing out entire rear end again right?

Took it apart and pounded it straight with a rubber mallet got it pretty straight but still had a slight bend.
So when I put it back together I reversed the tower so it will straighten up its self
I had a couple of failed landings can't tell if it was tail or nose. Get a bit exited after about 10mins into a session !!
Still I'm happy I had no chassis taco effect happening !!