wheelie bar repair attempt

Nice, Did it hold?

yea still holding.

Great ill try that too, thanks

Just to let you know this wasnt a normal break at the end of the wheelie bar. If you look closely it was in between the two mounting holes (closer to the left one) This is probably why its still holding up since the wing brace helps keep it together.

If its a break near the back of the wheelie bar then it probably wont work. Wont hurt to try though

Mine is broken on the second hole in the middle so i hope some metal and zipties wil hold it together.

Glad yours is still surviving, could you send a close up on how you fixed it with the metal thing?

You can see it under the tape. Cut two pieces. One piece on the top and one on the bottom. Bent to make it fit. Just some random scrap I cut from an old computer case.

First I super glued the break. Then I used gorilla glue to glue the metal onto the wheelie bar then used the gorilla tape and zip ties. I think just one decent sized zip tie should do the trick.

Nice! Zipties, Gorilla Glue, and a little bit of creativity go a long way in RC! I was able to rig something similar to a broken A-Arm! And its still holding up!