Typhon Possible to fit a mid diff to a Team Durango DEX8?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Nick_66

Fairly New Member
Messages
12
Reaction score
2
Arrma RC's
Hi all,

I wonder if it would be possible to fit a mid diff of the Typhon in a Team Durango DEX8. Anybody tried this and with succes?
 
I have it in my dex8. Had to use some shims to push the bearings out further to get them to fit in the diff bracket.
 
I should also note that the diff change will require a 16mm longer front driveshaft to make up for the extended shaft on the dex8 diff.
 
I have it in my dex8. Had to use some shims to push the bearings out further to get them to fit in the diff bracket.

Hi,

Could you send me some pictures of your DEX8 how you managed to fit that Arrma Typhon diff? Thanks!
 
20181019_213345.jpg
 
20181019_213710.jpg


Used these 8x10 shims to push bearings out to fit in the wider diff mount of the dex8.
 
Oops......never responded! Sorry for that!

Anyway, good to know that a center diff from a Typhon can fit a DEX8. I wonder if the bottom plate of a Typhon will fit a DEX8? If so, then you could use the motor mount of a Typhon.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top