JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser .
Typhon V5 Titus
A Typhon V5 BLX with a little beef.
General RC Information
A Typhon V5 BLX with a little beef.
Brand Part Scorched Parts Carbon Fiber Shock Towers Garage Life RC Shock Tower Protectors Arrma Aluminum Center Differential ADU Racing 7075-T6 Front Upper Suspension Block ADU Racing 7075-T6 Front Hinge Pin Holder ADU Racing 7075-T6 Front Rear Suspension Block ADU Racing 7075-T6 Rear Rear Suspension Block ADU Racing 7075-T6 Rear Front Suspension Block ADU Racing 7075-T6 Sliding Motor Mount ADU Racing 7075-T6 Front Center Brace ADU Racing 7075-T6 Rear Center Brace ADU Racing Hard Steel Hinge Pins ADU Racing 7075-T6 Servo Mount ADU Racing 7075-T6 Top Plate RPM Front Bumper and Skid Plate 3DRC Wing mount Scorched Parts Titanium rear skid plate
RC Type
Buggy
RC Brand
Arrma
RC Model
Typhon 6s V5 BLX
RC Scale
1/8 Scale
Technical Specifications
Power Source
Electric
Battery Type
LiPo
Motor Type
Brushless
Drive System
4WD (Four-Wheel Drive)
Top Speed
40-59 mph
Additional Information
Budget
$600-799
Challenges Faced
I needed to mill the servo mount posts to lower the servo and reduce the amount of M3 washers needed in the servo linkage. It was just too high. In the end it was nice and level.
Build Thread
https://www.arrmaforum.com/threads/bruces-typhon-v5.72340/
Titus1.webp
136.3 KB
· Views: 227
Titus2.webp
158.3 KB
· Views: 1,433
20240827_223004.webp
285.5 KB
· Views: 61
sc-skid.webp
166.3 KB
· Views: 49
20240831_183247.webp
354.8 KB
· Views: 54
20240908_010847.webp
136.4 KB
· Views: 44,632
