arrmarc

I have a spektrum servo in a 3s, its responsive, it has throttle. The problem is, it doesn't turn like how it suppose too. It slightly has some steering, it moves an inch or less in either direction. I can't figure out why it doesn't turn fully. Is it me that I missing and not seeing something...

Proline, traxxas or duratrax tires/wheels? Which brand of tires is your go too, you prefer or doesn't matter at all as along they perform on the road or track? I heard proline it better, top notch, little pricey but worth it. What's your opinion?

Not sure if this is the right thread for this question for the pinion gear. The smaller the number on pinion gear the faster or is it the bigger the number the faster? I know it also depends the motor and spur gear too. ⚙ I just need to know which the number is the faster and slower. Thanks.

Orange body is official for shelf purposes since I can’t seem to find another.

Yeah this happened. How do I access to replace a new back wheel drive shaft? My thought is, I have to get in the diffs to remove the other part. I can't figure out how to get to it. I took it to the track last weekend and that pop out and the servo is dirty or block. I'll work on the servo...

Lubricant or silicone lubricant? Which one to use to clean rc. I need to clean my rc, checking the bearings etc. I heard this and that about simple green and WD40. I'm cleaning it by hand, with brush, rag and a compress air can.

What's the easiest way to clean my RCs, they are really dusty? I saw some mix reviews about using a silicone type like wd40 to spray. Can I use one called super tech spray lubricant? What can I use on the diffs? Most of the dirt is on the front and back of the diffs casing. Any suggestions is...

An #ARRMA #Talion pulling my Proboat BlackJack 42 rc speed boat to the lake 💪💪💪💪💪💪

I have a Kraton 8s exb with 39t/39t the pinion move to the motor I take out the set screws with no problem. But I can not take out the pinion. I hot it with torch but nothin. I tray a puller with to arm but was to big to get between the mount and the pinion. Any suggestions?

Said I wasn't going to get an electric car.... Nothing against it, my daughter got the wltoys124019 4s 3660 3800kv.......just nothing on the market to MAKE me want to build a 80/20 speedruns/bashing (electric vehicle) until i went with brother to my local hobby store he bought a jato 3.3 nitro I...

I recently stripped my composite spur gear when i changed my pinion to 14t. I feel like it was a mesh issue that stripped it but to prevent further stripping of spur, Which steel gear works with the Senton 3s BLX V3. I have seen that the 4s steel spur might work but I would need 4s slipper pads...

Typhoooooon

New chassis!

I just recently replaced my rear wheel hub, and recalibrated the esc, along with new wheels. Once I was off to run it, the car struggled to move at around 15%throttle. under that it was running perfectly fine. I held the car in the air and it went full throttle no problem. once I put it on the...

Drivers / Cars Keith H / Losi Truggy / @Uplift-RC / v3 6s KRATON @jkflow / v3 6s Talion / Slim 8s Outcast

#proboadyrc #Unbreakablebody #russia

I recently made my big rock 4s capable and holy poop that thing is a whole new beast. My only issue (rather, root/main issue) is that when it gets to around 50 its still accelerating with no intention of hitting top speed for a while. Well once it gets to the 50 mph threshold it starts to wanna...

New shoes, new rims, ready to go street racing.