differential

My Mojave is still pretty new only about 5-6 runs. I wanna get in and service all the diffs and shocks. Replace fluids. Also have read stuff about shiming, watched some vids on it but any other advice would be appreciated. For the diff f/c/r what should I use and also where is a good place to...

So I purchased new hot racing steel gears and input shaft with a hot racing aluminum carrier case, the stock case holds Metal Gears inside of it when I pull those out I want to clean them can I soak them in gasoline to clean them because I don't have a hobby shop anywhere near me, this 550 has...

So i fitted the GPM alu diffhouse in the rear, very nice.. but my problem is, now the rear axle seems too short all of a sudden. There is about 4mm play lenghtwise.. too much, compared to the stock one, or the one at the front (stock) Im afraid if i let loose on the throttle ill destroy the...

I'm aware there are other threads for people who have noted blown rear diffs on their Kraton EXB. I'll share my experience, what caused it to happen and note the potential fix based on what Horizon Hobby told me, as well as the other gracious forum members who have shared their experiences and...

Recently purchased the exb roller and the shims needed for the rear diff are out of stock everywhere in the UK ?‍♂️ I've hunted for something the same but have had no luck. I don't suppose a anyone has a link to something I can use as most places are saying October before the parts are back in...

stripped the rear diff (not the fist time) and when doing the usual rebuild it seemed extremely tight and notchy, i have done all the normal stuff, moving the shim to the other side, no shim, lessening the yoke a little and its still notchy the input gear, ring gear and yoke are all new, the...

I will preface this in saying I haven't killed or damaged a diff yet, but I'm in the process of making a stupid setup for my Typhon V4 and would love to know if anyone knows of upgrade paths for the differentials. I've tried the search function to no avail, thanks in advance :)

What are the correct shim size for All 3 exb diffs? Is shimming necessary in the middle? Thank you!

Can I please get some diff fluid recommendations? I currently still have the stock fluids in place. I mostly just drift around in the yard, wheelie, small jumps, drive up a couple trees and back flip down to the ground, fly down the road and hop back into the yard. I've had it for a little...

So I’m on my third or fourth pack and the rear differential is clicking.!! I thought these diffs were supposed to be better !! I’ve been babying this thing. There’s something wrong Once before the same diff wouldn’t turn right with the truck off the ground. I took the diff out but couldn’t find...

Well, after cleaning up my leaky diff and tightening the screws that go into the spur gear and diff case, I took the kraton for a test run to see if it still leaks, it didn’t really leak but I think the leftover diff fluid (from when it was leaking) Got all over the pinion gear and lubed the...

Hey everyone does anyone know if the Kraton and outcast 4s diffs will fit into the granite 3s because I’m hoping that the 4s diffs will last longer! Any help wanted thanks!!!

i have had this kraton for about 2 months (one of which i was wasnt on parts so it wasnt used) and during this time i have ran about 8 batts though it (4s) and stripped 2 rear diffs (ring gear both times [i think im typing this just after my 2nd diff blew but it feels the same as last times])...

Hi All. Can someone please suggest the best suited differential oil for regular maintenance on the plastic diffs on my Granite Mega 4x4. I am still running the stock 12T brushed motor and 14T pinion. 2S lipo battery. I am looking for a balanced oil....not too thick, not too thin. Thanks.

Broke the rear diff the other day when I landed with apparently too high wheel speed. The internal diff gears are fine, it's the input gear and output ring gear that are both stripped. I'm replacing the gears now . I'm finding that the mesh is far too tight and I cannot get smooth action out...

So as the title says, I think it would be a good resource if people with an Infraction post up here what weight oil they are using in all their diffs F/C/R..!! Post up what spec your Infraction is and the type of driving you do, that way we can all learn from each other about what's works...

Trucks 2 weeks old now. My 6th time taking it out on grass, gravel, and pavement. Nothing serious and the truck hasn’t been higher than a foot or so off the ground. Today 5 minutes into my bash the truck just locked up and wouldn’t move. After going over it I realized the front axle...

Wow! I’ve only had to limit less for one week, and drove it may be 10 times max. And I’m only running Mamba Monster X, with a 6s Arrma motor. I was going to put some time and effort in this one.... but now... I may not even rebuild it... Arrma tough my A&$!

I Drove this truck for the first time today and I the metal that sticks out to hold the DIFF OUTDRIVE broke. Can this be fixed? I know I can replace the DIFF OUTDRIVES but I have seen nothing about this piece of metal that the DIFF OUTDRIVE connects to. I have added a photo and you can see the...

So what’s going on guys , I’ve just bit the bullet and bought myself a bran new typhon 6s blx, already burnt out my stock tyres and flipped it a few times ??‍♂️? but no chassis damage I have grinded my rear diff and it was kicking out to badly , with a little messing about I discovered only...