differential

So i see lots of ppl talking about diff fluid weights in the 6s lines but I cant seem to find much info on the 4s lines. I think the stock front and rear diff are 6k for outcast and kraton. Would going to 10k be too thick as the truck is a lot lighter and I see lots of 6s guys running 10k on...

Hi there, Yesterday i was cleaning up my typhon and i noticed that the front left wheel is not turning as it should. Also when i push the throttle, that wheel stops earlier compared to the otter wheels, probably a diff problem? Maybe someone had a similair problem?

Hi all, just a couple of newbie questions here about the notorious but probably applies some what to all the 2019 v4 range, i’m going to be changing the diff oils soon, is there any tips or tricks i should know before hand, also i was thinking about running a 30k/125k/30k setup, how different...

I seem to be having a reoccurring issue with the input gear of the rear diff of my outcast 4s. It got so bad that I only had front wheel drive, took it all apart and noticed I had completely crowned off the input gear, so it made sense why i Had no rear wheel drive... however I’ve just replaced...

Hello all!! Quick question- well I hope it’s quick. car is running well- no grinding or other noises. The passenger side front tire is free spinning. Power is being distributed amongst the other 3 fine. No grinding and car is still drives “normal” outside of bearing right because the wheel is...

I wanted to build a bullet proof diff but I have huge difficulty to find following parts. I search by Hobby King and some more vendors but nothing to do... all OUT OF STOCK All these parts are shimms to improve the diff durability... Help me , where can I buy them? BASHER 9655000127-0...

I’m putting a center diff back together for a kraton 6S as I got the HR diff casing for it. I have everything put together and went to screw it on and the screws that were holding the diff together before are too long. I’ve tried other types of screws and nothing worked properly. Is there...

Are the 4s diffs any stronger than the 3s ones? Just wondering as I’m running 6S in a BRCC and I know I will end up with diff problems and that they are the same size diffs.

So I finally got my rear diff parts in the mail for my outcast 4s, but didnt think to get the reccomended silicone diff oil for it at the same time. Is there a different kind of oil I can buy at my local parts shop or department store? Because the closest hobbyshops are 2+ hours in either direction.

My friend has a v2 kraton and he just keep having diff issues and he just told me he spend 120 cadandien $ to rebuild is diff... when i saw him the whole diff from jennyrc for 50$ he was shocked. Any suggestions to make is car bulletprof and i showed him the new kraton bpdy for 40$ and i think...

Im starting to be really pissed off at my kraton 4s today my diff gave out again while doing speed runs...i thought my sun gear gave out but it turns out that the whole diff is gone. Whats going why is is only happening to me? Its my 4th diff failure..

I have been ussing white lithium grease for a while now and my front and rear diff makes clicking noise when i remove the driveshaft and motor... and when i open the diff its bone dry with a bit of white on the teeths:/ should i use high weight silicone oil instead? Because the greases i tried...

Hello, the bigger Bearing in the Rear Diff is broken and i must change it. I have the rear Diff Case open and take off the Diff and also the Spiral Cut Input Gear and the little Bearing but the bigger Bearing i am not Able to get out. Is there a Trick maybe? Thank you!

I was outside testing my new servo when suddently my rear differantial once again gave up but not becaus eof my slipper clutch but because of the bearing who over heated and killed evrything.:c could this be covered by the warranty this ruined my day:c

Hi everyone, First of all, thanks to everyone in this forum, I've bought my first RC car after years of wanting one, and have had it since Christmas. My Kraton V3 has been incredibly fun to bash, and upgrading it has been really enjoyable. Since it's my first RC, the info here has been...

After i have shim the diff with two 13/16 shim The pinnon gear still very loose, i tried to put two 8x12x.2 and the fit is perfect and after 1 pack i reopen my diff and the shim is completely trash ?

Not sure if people have seen this so I thought I'd just leave it here, no more need for Hot Racing..?? https://www.arrma-rc.com/part/ARA220050

Hi guys, I'm running my new Typhon 6s V3 for a couple of days now and I noticed something with the center diff. If the car is off, and I try to push it, i have to push through a sort of barrier (maybe this sounds stupid ?). It is also a bit jerky. And it is making a lot noise, I know this is a...

Since I was working on my Kraton and another member just muddied his up, These SHOULD be safe for use on some RC stuff. They are both supposed to be composite safe and I use them all the time for other things that have a lot of plastic of some grade or another. I changed out/added diff fluids...

Don't let the title mislead you: Some of the wreckage is my fault. I'm new to the hobby. Its also been 32 or below when I've used the car. However, at this point, I think I'm going to put the Kraton away. Today I broke my rear diff housing (AR310427) AGAIN along with the composite hinge pin...