AJ242
Active Member
- Messages
- 87
- Reaction score
- 56
- Arrma RC's
- 4x4-Mega
Hi all.
I'm changing the pinion gear (after the usual battle to get the over thread-locked original one off ?). I’m new to this and can’t decide which way round it should go - with the grub screw nearer the motor, or further away. I can get good mesh either way but I’m leaning towards with the grub screw nearer the motor (opposite to how it came assembled) because otherwise the grub screw is a bit close to the end of the motor shaft.
Many thanks in advance.
I'm changing the pinion gear (after the usual battle to get the over thread-locked original one off ?). I’m new to this and can’t decide which way round it should go - with the grub screw nearer the motor, or further away. I can get good mesh either way but I’m leaning towards with the grub screw nearer the motor (opposite to how it came assembled) because otherwise the grub screw is a bit close to the end of the motor shaft.
Many thanks in advance.