2nd ESC still red flashing

[earencibia73]

Hey ,so I got brand EXB k6,got electronic from JennysRc, Ted sent 2nd ESC plug in ,still red flashing red, no power receiver or servo unless power direct,my battery new charged,Radio trim set on Throttle, know thinking WTF!!!Mang!!!
Any ideas?? Thanks





























































































































































































































































































































































I bought

 

[norcalsc]

it's really hard to understand what you are saying

 

[parcou]

Hey ,so I got brand EXB k6,got electronic from JennysRc, Ted sent 2nd ESC plug in ,still red flashing red, no power receiver or servo unless power direct,my battery new charged,Radio trim set on Throttle, know thinking WTF!!!Mang!!!
Any ideas?? Thanks





























































































































































































































































































































































I bought

I had an issue like this and on the three-pair wire coming from the ESC it was cut...well one but the other two were intact. But you got a new ESC so this is an odd one. Servo wires nothing snagged or cut.

 

[SrC]

2 bad ESC's in a row.??? Probable but very Unlikely.
I will guess that the first ESC was fine, as is the second one. And you are doing something else wrong there.

Double check the ESC and Servo plugs at the RX ports. For Correct polarity.

If the Servo did only work, I would say you need to calibrate the ESC to the radio. But I don't think this is the issue at all.


Try rebinding the Radio with the RX again. Then recalibrate the ESC with the radio. In this order. Radio and ESC manual in hand.
Because you have both NO Servo or ESC response. Perhaps a radio/Rx issue. Not bound. (No signal)
Did you even do a bind first?????
You never stated what Radio set you have in there. This could help us to help you better.. You seem focused on the ESC. Look at the big picture. Need more info.
Get back.