3 diff parts questions.....easy !

[*420+3RC*]

https://www.ebay.com/itm/Arrma-TYPH...2349624.m46890.l49286&mkrid=711-127632-2357-0

Do the 3s typhon and 6s typhon have the wing mount holes in same position??

The carbon fiver Big Rock wing looks good But with it mounted on body wouldn't that rip thru and trash body worse?

I'll have to look for the 3rd item and post it in a bit

 

[Edough13]

Yes the wing holes on both the 3s Typhon or 4s Noto are the same width apart as the 6s wing holes shown here but if you notice the 3s/4s wing holes are a lot further forward than the 6s wing.
Yes the wing being mounted to the body is not a good design as it will rip the body apart as you said over being actually mounted to a wing mount.

 

[*420+3RC*]

Yes the wing holes on both the 3s Typhon or 4s Noto are the same width apart as the 6s wing holes shown here but if you notice the 3s/4s wing holes are a lot further forward than the 6s wing.
Yes the wing being mounted to the body is not a good design as it will rip the body apart as you said over being actually mounted to a wing mount.View attachment 171179

Right thats why I had to cut my wing. It's a mega wing. Would the Talion wing I put link up for mount up??

Also heres the 3rd part. It's the aluminum typhon wings. https://www.ebay.com/itm/Arrma-Typh...2349624.m46890.l49286&mkrid=711-127632-2357-0
Of course with different engraving for the BR instead. No care that its aluminum. Im just sick of this mega wing. And would like something that isnt on all other BRs. Ideas?

 

[Edough13]

The wing above would be the same and need trimmed in the front to get it on the wing mount as the holes are further forward. Same with the aluminum one might be easier to just drill new holes in the wing instead of trimming the front off.

 

[Edough13]

Here ya go I just mounted an older Kraton 6s wing that I had with the center trimmed out as it was broke but fits perfectly think I'm going to leave it I like the look with the bigger wing