FAILWISH
Active Member
- Messages
- 71
- Reaction score
- 42
- Arrma RC's
- Typhon 6s
On my quest to avoid using the on board bec for led power.. i did a voltage test on full 4s and 6s lipo charge port the outer two wires are the true voltage coming from batt..what ever the total power from the lipo is also coming from these wires..
I looked around and found some kits on ebay figured i would test and make my own.. went to amazon got this particular bec that knocks 6s power down to 5v.. and ran them for 40mins on my led set ups to verify heat put out..they get warm(holdable with hand and back of hand noticable warm) but never hot .. 40 mins is my test time since i rarely go past 45mins of play time. These pics show the input side has a 6s charge port and a jst on the output side.. added extra pics to show with and with out bec 5v step down
I looked around and found some kits on ebay figured i would test and make my own.. went to amazon got this particular bec that knocks 6s power down to 5v.. and ran them for 40mins on my led set ups to verify heat put out..they get warm(holdable with hand and back of hand noticable warm) but never hot .. 40 mins is my test time since i rarely go past 45mins of play time. These pics show the input side has a 6s charge port and a jst on the output side.. added extra pics to show with and with out bec 5v step down