TooManyHobbies
Active Member
I've been thinking of something I could use to support the end of my Leopard 56110 coming in a couple of days. I looked around and found the perfect candidate, a Champion rubber football kicking tee.
Now, these can be had for $5 if you don't already happen to have one sitting around. Obviously you are gonna have to mutilate it, but the curve on the concave part is almost perfect for my 56mm motors, just slightly smaller, but can slot in perfectly.
You will have to use an exacto knife to make the part that sits on the motor flat. I'm gonna drill holes through it and the chassis to bolt it down to make sure it stays nice and secure. Also am gonna clean it all up and paint it black so it doesn't stick out as bad
Now, these can be had for $5 if you don't already happen to have one sitting around. Obviously you are gonna have to mutilate it, but the curve on the concave part is almost perfect for my 56mm motors, just slightly smaller, but can slot in perfectly.
You will have to use an exacto knife to make the part that sits on the motor flat. I'm gonna drill holes through it and the chassis to bolt it down to make sure it stays nice and secure. Also am gonna clean it all up and paint it black so it doesn't stick out as bad
