Typhon Advice please

[brett1]

I’ve just been bashing my new typhon 3s v3 no the local quarry it really slugged up can I just wash it down with a hose pipe? Or will that damage the motor or ecv. Servo or are they fully waterproof or could any body advise best way to clean. I’m new to all this. The typhon is awesome really easy to drive and great speed and power.

 

[jkflow]

I leave this here:
https://www.arrmaforum.com/threads/how-do-you-clean-your-rc.1978/page-13#post-471350

 

[GraniteFox]

Spray off with water is fine if mud, just avoid the motor and electronics. Dry off with a rag then hang it to dry upside down for a little bit. Once dry I use the wd40 silicone spray for the metal parts to prevent rusting And you are good to go. Overall yes avoid direct water to the electronics if you can. Many people have different methods and they all work fine. Personally I do not like the standard wd40 as I fine it opens up screws to back out and attracts dirt....IMO

 

[jkflow]

Just do not use WD40 on the bearings either, surefire way to destroy them in a short timespan. Oil them or use silicon based stuff that leaves no residue.