Typhon Another newbie question

[joshludden]

I'm replacing the stock servo horn with an m2c on my typhon 6s. How do I know which one of the three holes to use? Do I use the middle hole? That's the one that makes the most 90° geometry all the way around. Thanks for any help

I'm replacing the stock servo horn with an m2c on my typhon 6s. How do I know which one of the three holes to use? Do I use the middle hole? That's the one that makes the most 90° geometry all the way around. Thanks for any help

Here's a picture

 

[L3phturn]

I'm replacing the stock servo horn with an m2c on my typhon 6s. How do I know which one of the three holes to use? Do I use the middle hole? That's the one that makes the most 90° geometry all the way around. Thanks for any help

Here's a picture

Which hole is closest to stock? No point in going longer and then having to set your end points lower anyway.

 

[Jgg12002]

Check endpoints anyway and adjust if necessary.

 

[dure16]

Which hole is closest to stock? No point in going longer and then having to set your end points lower anyway.

Agree. Plus going longer reduces torque(less leverage).