Kraton Arrma Kraton build by Crash

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
When did Hot Racing start making the cover for the bulkhead? I know they make the sway bar cover thing, but was not aware they were making the front half of the bulkhead.
 
I know; when I built out tomahawk Kraton the front bulkhead case was not available or shown anywhere. I picked up 3x sets and deanodized one set for my senton build.
5EAD2B37-458B-4210-9978-5F08F128D1A9.jpeg
3D6F9071-D3CF-4442-A85E-359BB05209F8.jpeg
F3D628A2-33E8-4E46-981F-E0CD7BE122A1.jpeg
 
I was thinking about getting those cases for my outcast, but for $80 an end... I was holding off.

The fitment of the case cap and case looks a bit off:
2018-0925-HotRacing-ArrmaDiffCaseGap.jpg


What's with the gap? It looks like the top/bottom is fully seated, but that gap kind of weakens the whole thing and will allow crap to get in there.
 
They fit together well it’s kind of deceiving. I also test fitted bearings and all is normal. Will provide update when I start build of the diffs.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top