Arrma Limitless / Infraction 3D printed front skirts

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

magnetik

Active Member
Messages
174
Reaction score
544
Location
North Little Rock, Arkansas
Arrma RC's
  1. Infraction
finished up the front skirts for the Infraction. I'm assuming they'd fit a Limitless

UPDATED: I updated these slightly fit better since originally posted.

https://www.thingiverse.com/thing:4321402
P1012042.JPG
frontskirts.jpg
 
Last edited:
I noticed those screw holes the other day when I was fiddling with mine. Is there a stock part these are based off?
 
Printing them up now. Single color though since they will see some heavy scuffing :)

I made them thinner then the side skirts.. also beveled them so they're below the front difuser screws
What did you print the out of?

PLA. I plan on reprinting in petg eventually since it gets hot around here
 
Nice work guys, look factory! ?
 
Thingiverse.com
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top