Arrma spur gear

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

JoeLauber

Member
Messages
83
Reaction score
12
Arrma RC's
  1. 4x4-Mega
  2. Granite
https://www.arrma-rc.com/part/ARA310945

I found this spur gear and I was wondering I'd it could fit in my arrma granite 4x4 mega that I'm converting into a brushless will this work on it and does it go together the same way for the slipper clutch and all that or do I need to modify it
And do the slipper pads fit on there
 
They both us the ARA311030 spur gear. I have the Typhon Mega modified for 3s and I use the metal spur.
 
Yes, that's what I use on my Typhon. Keep this in mind though, when using metal parts you are transferring the shock and possible damage to the next weakest part.
 
Err... I think that spur gear is for the BLX slipper. You can use the gear, but you need the entire BLX slipper to go with it.

The Mega slipper has a bearing offset on one side and slipper pads on the other. The BLX slipper has a centered bearing, and slipper pads on both sides. The spur in the picture does not have the offset bearing sleeve, so it will NOT work with the Mega slipper.
Easiest way to upgrade is to get a complete BLX slipper from the Ebay kit breakers -
https://www.ebay.com/itm/Arrma-SENT...t-ARA4303V3-/373217436832?hash=item56e57e24a0

Note that the motor/spur spacing will be different with the 32p gears that the BLX slipper uses, so you will need to either modify your plastic mega motor mount (slot the motor mount holes) or buy a BLX motor mount -
https://www.ebay.com/itm/Arrma-SENT...n-ARA4303V3-/373217434318?hash=item56e57e1ace
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top