I read a lot about weak A Arms and how everyone is waiting for RPM to release some for the K8S. I got to give Arrma credit. Yesterday, I was backfliping off fences and putting a lot of stress on the suspension from it in addition to typical jumps and flips. Today I’m doing the same thing when a screw fell out for the rear tie rod. Found the screw put it back in and noticed this on the front.
A chunk got taken out somehow yesterday during all the flips and tricks, and it held firm.
After discovery it I took it a bit easy, but not really. Jumped it several times higher than usual, took a few tumbles and so forth. It’s still working.
My truck is pushing 32 pounds, and it withheld a lot of stress over the past two days, and it still haven’t snapped yet...whoever says these snap easy is clearly landing on them to cause it. This thing should not be intact after what I put it through.
Arrma Tough!!
A chunk got taken out somehow yesterday during all the flips and tricks, and it held firm.
After discovery it I took it a bit easy, but not really. Jumped it several times higher than usual, took a few tumbles and so forth. It’s still working.
My truck is pushing 32 pounds, and it withheld a lot of stress over the past two days, and it still haven’t snapped yet...whoever says these snap easy is clearly landing on them to cause it. This thing should not be intact after what I put it through.
Arrma Tough!!