Vendetta Arrma Vendetta Hot Racing Slipper

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

christikfa

Fairly New Member
Messages
21
Reaction score
3
Hi All, Have only had my Arrma Vendetta for a few months and recently bought a set of GRP tires for it, First drive I've stripped the inner plastic sleeve on the slipper. I don't do speed runs or anything like that just the casual few laps around a track. I'm assuming the bigger tires have caused the issue. So I've looked around thinking of getting a
-Hot Racing Slipper Eliminator
-Harden Steel Spur 50T 0.8
-New Slipper Shaft

As I'm new to RC Cars I'm just wanting to know if there is anything else I should be getting to help beef any potential weak parts while I'm at it. Any suggestions to buying different stuff is more than welcome.





313403279_10229704540262962_7448376798379996731_n.jpg
313105337_10229704540382965_8660240879737144517_n.jpg
 
Last edited:
That’s exactly what you need , I went through the same thing . I was so very pleased when I made the switch ti that set up . That will keep you going perfectly . just need to watch your axle’s because they can start popping . But if you keep it on 3 s you should be good for a while
 
The perfect man to speak to hah! Did you need to get new bearings or anything or did you use the ones that were on before? Also, this part screws off right and goes on the new slipper? As I'm in Australia I need to order everything from US and want to try do it once.


Capture.PNG
 
You’re not going to need anything from that set up with your new set up, your bearings will fit just fine . The HR aluminum drive shaft is a nice addition this is what your new set up will look like . Order 2 nipples they are cheap enough I haven’t used my second one my first one still works perfectly the nipple just goes in the eliminator and the driveshaft

834A4238-F84B-4DFF-9B4B-77481B79E0C3.png


0326C6A8-AED7-4158-ABB5-61FAEB34EBAC.jpeg


2CCAF50D-2CE6-492A-AC09-E71C778A6165.png


CABF0719-E83B-4F6C-B695-248BD44E42C0.png


3C1FCE08-5F47-460F-B70B-9306A6741613.png
 
Thanks so much,Also Which nipple are you referring to? I think that is all I need, Need to get the slipper shaft from somewhere else. Is that the correct centre shaft you have.




Capture.PNG
 
Last edited:
You need that to go from eliminator to drive shaft . Also you can most likely tighten down your current set up and run the car until your parts come in there’s a 2mm down in the assembly through the red shaft that comes loose all the time

FAA8CB5C-04BC-4B6C-9DAD-A603575CE525.png
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top