Outcast Bellcrank broken (stock. Upgrade or use stock?)

[Armarookie43]

My bellcrank cracked (the part on top of the servo saver). Is there anything worth it to upgrade, I just buy the stock one? Thanks. V2 Outcast 6s.

 

[Outcastblxnut]

M2c make the Ackerman plate.

 

[adidas303]

I tend to see members suggest to upgrade to an aluminum bellcrank, if feasible, as it will tighten up the steering quite a bit. Allow a lot more handling. Probably a lil more durable in harder hits while bashing.

 

[Armarookie43]

M2c make the Ackerman plate.

Yeah nice, but that's not what broke. It's the part right above the servo saver that broke. Is the hot racing bell crank assembly any good? Thanks.

 

[Armarookie43]

I went with this. I'll see how it works out :
https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/193126024017

 

[adidas303]

I hear the HR bellcrank is decent. I know some of them are super expensive as well, between like $40 - 100 bucks!

I'm liking that GPM Bellcrank you found as well! I might have to look into those down the road!

 

[Hammer Down]

I run the HR bellcrank in my K6s and so far so good. ?

 

[Armarookie43]

I hear the HR bellcrank is decent. I know some of them are super expensive as well, between like $40 - 100 bucks!

I'm liking that GPM Bellcrank you found as well! I might have to look into those down the road!

I'll let you know how it goes once I install it and bash it.

 

[Armarookie43]

I hear the HR bellcrank is decent. I know some of them are super expensive as well, between like $40 - 100 bucks!

I'm liking that GPM Bellcrank you found as well! I might have to look into those down the road!

Don't get the GPM bellcrank BTW, it had some weird play on it that I could never get rid of.