Kraton Bent Chassis?(pic)

[Michael24]

Run it any way or park it? It's gonna be a week or 2 till new chassis arrives. Drivetrain sounds a little off, but no where near binding. I've seen many people run them with bend's or do think i'll wreck it. Any advice would be greatly appreciated Thanks.

 

[hobo]

totally fine to run that. hope your replacing with m2c one

 

[slick2500]

Is that brand new? Just send it. That's not even bent.

 

[Michael24]

totally fine to run that. hope your replacing with m2c one

most likely m2c, yesterday a good thread showed up with info thanks.

Is that brand new?

a couple month old it's seen some airtime & cartwheels just on packed snow. Still looks new.

 

[Adiabatic]

Mine wasn't even that straight out of the box. The stamping process doesn't seem to leave a consistently flat chassis like machining would. I only bothered to bend it back once it had tweaked enough to make me worry about the rear centre driveshaft popping out.

 

[JKWoods]

Yeah that don't seem bent much at all.

 

[Michael24]

Thanks guy's i just needed a little encouragement i'm gonna wreck & rebuild anyway!

 

[Kingleo619]

The ruler is bent you good

 

[Michael24]

The ruler is bent you good

Double checked both ruler's are bent good too go!

 

[slick2500]

most likely m2c, yesterday a good thread showed up with info thanks.

a couple month old it's seen some airtime & cartwheels just on packed snow. Still looks new.

This is bent.

 

[Camaroboy383]

Absolutely run that, just keep an eye on the center drive shafts to be sure they can't come out if it gets a little worse...