Big Rock Big rock steering center issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Niko69

Fairly New Member
Messages
6
Reaction score
5
The steering doesn’t work well. When I turn right and then leave the hold of trasmitter , the steering comes back to center perfectly. But, when I turn left and leave again, it doesn’t come back to center. I changed the stock servo with Annimos one but nothing change. I’ve also changed the stock steering block with the HR ones. Which could be the problem? How can I solve?
 
I had the same problem when I switched my bell crank and servo. Make sure nothings binding. It was a while ago, but I’m pretty sure the bell crank was sticking from me over tightening!??
 
Take the servo horn off and move it with your hands and see how easy it is to move.
 
The two plastic screws on your front knuckles are too tight. Try loosening both on each side
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top