Blue loctite..

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

abracing

Active Member
Messages
104
Reaction score
101
Arrma RC's
  1. Limitless
  2. Kraton 6s
  3. Talion
..put big drop of biue loctite on pinion gear grub screw. On limitless, running 6s, not holding.. anyone else have same issue ??.. afraid to use red..any suggestions ??
 
Use a little red just heat it up to remove.
Another option is disassembling a old bearing and using a single ball under the grub
Tried little bearing ball under grub screw, then a big drop of blue loctite..ran limitless 100+mph , until 6s was done, it held..thank for the tip..herd of doing this before at kart track..but forgot..lol..
 
..put big drop of biue loctite on pinion gear grub screw. On limitless, running 6s, not holding.. anyone else have same issue ??.. afraid to use red..any suggestions ??
Did you let it cure for 24hrs before giving it the hamm?!
 
Did you let it cure for 24hrs before giving it the hamm?!
Shure did plus some,more like 3 days before had time to mess with it again..then there is the Michigan weather..rain,rain..Guess know about weather being..in minnosota..lol..
 
Last edited:
That sucks!!
I’ve had the same issue but it was because I don’t have patients for loctite to dry... ?
I also put a dab on the pinion shaft now too.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top