Notorious Blx 185 6s Problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

NR notorious

New Member
Messages
3
Reaction score
0
Hey all
Just after some info on why my esc stops working and blinking red on my notorious 6s after only a few minutes running.
It also stuck on full throttle which lucky it didn’t damage anything.
I did read that blinking red is over heating but i can’t figure out why.
 
Maybe its a faulty unit, try reseting your transmiter end points ,(throttle,neutral,brake) just make sure your throttle sensitivity knob its at the half way position , if that dosent work try another remote remote and reciver, if that dosent work your esc should be replace under warranty.
 
I’ve tried doing the transmitter points. It worked for only a few minutes I’ll try a full reset other wise I will have to try the remote receiver. Thanks
 
Good luck, please keep us posted , your experience with this problem could help lots of people.
 
Slow and consistent green LED flashes indicate thermal cut-off, slow and consistent red LED flashes indicate LVC, and rapid red LED flashes indicate loss of signal
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top