BLX100 Blinking Red

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

BriMan123456789

Fairly New Member
Messages
14
Reaction score
4
I just picked up and installed a new BLX100 esc and new 3660 3800kv motor for my Granite. Running with 2s 5200 lipo. Upon turning it on, the esc just blinks red quickly. No motor power, and very very weak servo power. I've checked all connections, they seem fine. I can access the "tuning menus" which makes me think the esc isn't toast. I've tried multiple batteries, all topped off, and I get the same result. Majorly bummed!!! Any thoughts?
 
Have same issue with the blx185. I tried the factory reset, binding etc. With no success. Curious to know the solution
 
Mine was working properly. The issue showed after a long idle period.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top