Infraction Brake/reverse problem

[lilkoentjuhh]

Hey guys,

I have a problem with my v2 infraction. Yesterday I connected mine to my receiver, only on the confirmed I can't set the brake/reverse endpoint, because the light should flash to confirm, but it didn't confirm...
can someone help me?

 

[Go Arrma]

IDK, maybe reset the esc?

 

[Engineer]

Did you do anything with the receiver like rebind it? If so, did you go through the calibration steps after binding?

For setting the endpoints are you pushing the set button between positions?

 

[lilkoentjuhh]

Did you do anything with the receiver like rebind it? If so, did you go through the calibration steps after binding?

For setting the endpoints are you pushing the set button between positions?

After binding the receiver goes directly in calibration mode. First you have to go full throttle, then nautral, then full brake, then right steer, then left steer.
The receiver automatically saves the end points.

IDK, maybe reset the esc?

Already done, but it doesn't work

 

[marucci87]

After binding the receiver goes directly in calibration mode. First you have to go full throttle, then nautral, then full brake, then right steer, then left steer.
The receiver automatically saves the end points.

Already done, but it doesn't work

Did you wait till you get steering then set end points? These spectrum receivers take a few seconds of no movement on flat surface before they connect I wait till I get steering when I put it into the end point programming then set neutral then so on.