Brushless Granite cannot do wheelies anymore

[engineerangelo]

Hi! I recently upgraded my Granite Mega to Speed Passion 13.5T motor and Hobbywing Xerun Justock 60A brushless sensored system. And during my first run, the truck began to do wheelies. I even had it flip over after trying to make a decent wheelie. That run was just for a couple of minutes. And the next run I had, it doesn't wheelie anymore. And until now. I don't know what happened there. What could I do to check?

 

[slick2500]

Check your slipper clutch first, it may have loosened up on you.

 

[engineerangelo]

hi, retightened my slipper clutch to the factory setup as shown in the manual. But still no wheelies. Any other suggestions?

 

[slick2500]

Did you make any changes to the settings on the esc?