Calling all mmx8s 2028 owners

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Mystery solved. Apparently when I put the red locktite on the pinion set screws I also did the same to the spur set screws. (39/39 limitless spools) Well I must have moved the spur a bit too much to the rear and set the pinion to that. No problem till I put the cover back on the spur and it was rubbing the spur creating the binding. So I either move the pinion and spur (not) or run with the cover off (probably not) or hopefully I can trim the portion thats binding off and just start looking for a new rx.
 
So just to be 100% sure. There should be no problem running the bec at 7.5 correct? This is regarding the rx. Don’t understand why it just took a dump all of a sudden. Is there anything specific I should be looking for when I get a new one?
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top