Typhon Cant reassemble motor

[Captain Flint]

Finally got the bearings replacement for the motor but now it seems to sit perfectly bit i cant close it back together.
(Second picture is without the bearing, maybe something is wrong that i cant see)

 

[Ruben-RC]

try hammering it a little bit with a rubber hammer

 

[Switchblade2k]

Or press it together with a press. Bearings are designed to be "press fit", they won't just slide in easily if they are fit properly.

 

[Captain Flint]

doesn't budge at all

 

[Ruben-RC]

doesn't budge at all

make sure the bearring is pressed enough on the rotor, maybe there s a little stump where you need to press it a little harder to get it over

 

[Captain Flint]

make sure the bearring is pressed enough on the rotor, maybe there s a little stump where you need to press it a little harder to get it over

Cant push it more than this

 

[Camaroboy383]

Look at the shaft... the old bearing race is still on it... it needs to be removed

There should never be a reason to hammer or press the end of the can on...

 

[Captain Flint]

Look at the shaft... the old bearing race is still on it... it needs to be removed

thought it was part of it.... the old bearing just shattered inside so i never got to see it without it... thanks

 

[Camaroboy383]

thought it was part of it.... the old bearing just shattered inside so i never got to see it without it... thanks

It's common for them to come apart... always remember there is always an inner and outer race to every ball bearing...

Keep an eye on that front bearing, alot of crap has the potential to jam in there and waste the bearing.. I check and service mine every 6 packs

 

[Surchaufeur]

Yeah that thing is part of the old bearing needs to be removed

 

[Captain Flint]

It's common for them to come apart... always remember there is always an inner and outer race to every ball bearing...

Keep an eye on that front bearing, alot of crap has the potential to jam in there and waste the bearing.. I check and service mine every 6 packs

Closed perfectly and runs smooth, gonna change all the bearings while im at it and go back to bashing

 

[Camaroboy383]

Closed perfectly and runs smooth, gonna change all the bearings while im at it and go back to bashing

Excellent buddy... glad you got It sorted...