Castle data help

[Mattyd926]

Ok so I’m trying to understand the data . I want to be able to look at it and make adjustments from there. This is for a drag car. So from the looks of the data things look good but why is my voltage dropping. I think I need a better battery. Was running 5000 100c .

 

[The Donut Man]

What's the actual voltage drop? Your battery has a plenty high discharge rate and capacity for what you're doing. Also, in the future setting the data collection frequency to the highest value will give you smoother curves to work with. Can you post a screenshot of the run instead of a photo of your screen?

 

[LibertyMKiii]

Voltage sag is very normal. During high loads 1v drop per cell is fairly normal.

I see that it reached 49k rpm during the run. That sounds good to me assuming the logs are not setup for a 2 pole motor in that scenario it would have been 24.5k rpm.

Did it not perform well?

 

[Mattyd926]

No it actually performed amazing for the first time was make killer hits then my Lipo took a poop so I need another. Probably smc 6400 150c I believe or is 100c fine ?.
I set the settings for the motor I forgot but it’s right lol