Charging adapter 2x2s and 2x3s in serial. DIY...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

lonee

Active Member
Messages
565
Reaction score
177
Location
Germany
Arrma RC's
  1. BigRock
I finished today the prototype of my DIY charge adapter to charge 2 x 2s and 2 x 3s in serial.
IMG_0002.JPG

IMG_0001.JPG
 
Thanks, the reason for that design was an mistake of an colleague which an big "Spark!".
We had used uncoded plugs in the past, but it takes a lot of care to handle that. -> Mistake! :confused:
Luckily the Lipo still alive but we had to solder an new balancer cable! :rolleyes:

Now that my girlfriend also has an Nero :nailbiting:, I had to find an solution to make charging "bulletproof".
Later on I will make the adapter inbuilt in a box with the connections coded like LiPo1 and 2.. or something similar.
Also I using a multiplex charger with BID and each board / box will get an chip.
It means: A girl takes a Lipo, just connecting the wires to Numbers, the charging values are already stored in the BID chip, and just pushing the start button....
What do you think, might it work? :)

Regards,
lonee
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top