Clarification when extending Kraton on Mojave chassis

[Kingpin]

Hi guys.
I am doing the Kraton 6s V4 conversion onto the Mojave chassis.
I thought I was told that I need the Mojave rear center driveshaft?
According to the parts pages that driveshaft is the same length (135mm) as the Kraton.
The front Mojave Center driveshaft is 157mm long...is this the one I need?
I'm utterly confused right now.

Here is what Arrma's pages tell me.
Kraton front - DOGBONE 116MM #AR310472
Kraton rear - DOGBONE 135MM #AR310460

Mojave front - DOGBONE 157MM #ARA310952
Mojave rear - DOGBONE 135MM #AR310460

 

[SrC]

Perhaps see if the front and rear braces are the same. The drive shafts coordinate with the braces lengthwise.
Best way to approach that is to get your hands on the Arrma Parts Cross-reference sheet. At Arrma's site in PDF. See what parts overlap each other on these two rigs. Hope this helps.
The conversion that was originally done was a Mojave with the Kraton parts. You are doing it in reverse with a Kraton to a Mojave chassis. Should not be any problem. Sounds like a nice project for sure.
edit:
I imagine you saw this already?
https://www.arrmaforum.com/threads/arrma-krajave-kraton-xl-build.20083/

 

[Kingpin]

Perhaps see if the front and rear braces are the same. The drive shafts coordinate with the braces lengthwise.
Best way to approach that is to get your hands on the Arrma Parts Cross-reference sheet. At Arrma's site in PDF. See what parts overlap each other on these two rigs. Hope this helps.
The conversion that was originally done was a Mojave with the Kraton parts. You are doing it in reverse with a Kraton to a Mojave chassis. Should not be any problem. Sounds like a nice project for sure.
edit:
I imagine you saw this already?
https://www.arrmaforum.com/threads/arrma-krajave-kraton-xl-build.20083/

I am doing the same as the guy in the videos. Thanks for the links.