Kraton Cooling fan.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Ole Fart51

Active Member
Messages
421
Reaction score
371
Location
Louisiana
Arrma RC's
  1. Nero
  2. Talion
I'm wanting a Hobbywing heat sink and fan. Does anyone know what part number that will work on my Momba Monster 2200kv set up?
 
The one I got for the stock v2 motor was this "Hobbywing Ezrun C4 5V" I'm guessing the monster can is around the same size ?
 
If it's 40-42mm it will fit. You may have to bend it in a little. Remove the fan before you tweak it....adjust the fins..then screw the fan back on. I posted some info on one of those fans on here under

https://arrmaforum.com/threads/motor-swap-in-kraton.1398/page-3 That's on a 2200KV Castle motor. If that's the one you are talking about.

Check out my mods to it....unreal cooling action. Works awesome.
 
Last edited:
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top