Does this look cool or is it ugly? I can't decide.

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
Is that paint or two filaments?
The red and black is two filaments. I set the logo and red stripe to be 1.5mm taller than the rest of the fin then did a filament swap mid print. I only have a single extruder ender 3 pro so I have to be clever about design and print techniques when I want dual colors. Did the same thing with the V1 side fins.

The "infraction" lettering on the center wing section is Gundam model marker paint. Did it this way because it wasn't the highest point of the print and would have had to swap filaments twice and have a weird white stripe in the middle of the rest of the print.
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top