Dual motor mount

[vwturbowolf]

Really like updated adjustment setup for the side screw to dial in the mesh. Great rework from the previous design.

 

[PPS-RC]

Really like updated adjustment setup for the side screw to dial in the mesh. Great rework from the previous design. View attachment 225896

Can't wait to see that one all together! Looks SICK!!

 

[vwturbowolf]

Can't wait to see that one all together! Looks SICK!!

Just wanted to update this. Car has seen 188mph on 7s so far.

Mount is holding up well.
I seem to lose the large allen grub screws for the adjusting bolt cover. But I must be setting it incorrectly

I need to order a couple new two or three packs of these that have egged out a little on me

But didn’t see them seperate from the top plate.

Is there a way I can get three packs of those and two more of the large grub screws for the adjusting bolts?

The ones that go here

 

[PPS-RC]

I'll be sending you a message.

The big set screws need to be tightened pretty tightly, and I recommend a little bit of loctite on them.

 

[Diem Turner]

I haven't had any issue with mine as of yet, but I'm also not flying at the same stratospheric levels you are.

@PPS-RC just curious, but are those grub screws metric or imperial threads?

 

[PPS-RC]

I haven't had any issue with mine as of yet, but I'm also not flying at the same stratospheric levels you are.

@PPS-RC just curious, but are those grub screws metric or imperial threads?

Imperial. 5/16-24.

 

[Diem Turner]

Imperial. 5/16-24.

Thank you

 

[vwturbowolf]

@PPS-RC got me the bits I needed quick and the spool is locked in place again