Picked up my used V3 Kraton 6s over the weekend. I was able to drive it before I took it and all seemed well.
Last night I went to take out the servo & mount to swap out. When I got into the receiver box I saw some electrical tape on the wires coming from the ESC. "That ain't right!"
After removing, I found this...
Needless to say, I wasn't too happy. My plan is to cut the damaged part out, cut the lead off of the old servo, and solder them together then heat shrink each wire individually. Does that sound like a good plan?
Last night I went to take out the servo & mount to swap out. When I got into the receiver box I saw some electrical tape on the wires coming from the ESC. "That ain't right!"
After removing, I found this...
Needless to say, I wasn't too happy. My plan is to cut the damaged part out, cut the lead off of the old servo, and solder them together then heat shrink each wire individually. Does that sound like a good plan?