- Messages
- 871
- Reaction score
- 1,800
- Location
- SE MICHIGAN
- Arrma RC's
- Granite
- Infraction
- Outcast 4s
- Outcast 6s
- Outcast 8s
- Typhon 3s
- Typhon 6s
Got a used 150 esc, went to change some settings and I can't get it to go into programming mode. I hold the set button, push the power button, contimue to hold the set button until red light starts flashing, let it go and push it again, green light blinks once with corresponding chime, and then that's it, won't go any further. It works fine, I have forward and reverse, fan works, it calibrated fine, but I just can't change any settings... any ideas??