dms70
Active Member
Ok so on my v3 Kraton I run the m2c chassis. I also have the m2c motor mount. I’ve recently noticed a lot of flex coming from somewhere in the center of the chassis. Meaning if I push down or pull up on the back of the motor can something is flexing. I should add I’m only using my finger strength to do this, and obviously know if you put enough pressure somethings gonna give. My question is has anyone else noticed this? My motor is a 4082 size can, so it not ridiculously long. I haven’t been able to pin point the cause of flex yet, but I’m looking into now. Just curious if any of you guys have seen this. Or if you have the same set up, could you see if the flex is there on yours, I’d appreciate it. Oh, and I’ve checked for the obvious loose hardware, and it’s all tight.