Outcast Front diff leak through bearing?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

LtGhost08

Active Member
Messages
99
Reaction score
57
Location
Waterford Michigan
Arrma RC's
  1. Outcast 6s
So I installed the new arrma modular diff in the center of my outcast. 500K fluid, assembled as instructed. While running yesterday I noticed at the bearing in the front center diff mount there was oil or grease around the bearing. I am wondering if maybe the oring is leaking. If this is the case is there a way to prevent this in the future? It is quite a bit of work to get that out and serviced. It is hard to tell if it is diff oil or bearing grease. I have fast eddy sealed bearings.
 
Could just simply be a little fluid seepage. Wipe it clean, run a pack through it and check it again.

The fix could be something as easy as making sure the O-ring is seated OR installing another flat shim before the sun gear pin.
 
Sounds good. Ill wipe it clean with a cotton swab and check again. It fluid wasn't slinging around the truck or chassis so it could just be seepage. Maybe overfilled a little bit. I did temp check the diff after a run once, it got up to about 120F. I do a lot of wheelies :)
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top