Fury spur gear removal

Theonlylukas

Well-Known Member
Messages
12
Reaction score
0
Arrma RC's
  1. Fury
Hello, as I was replacing a stripped spur gear in my fury I noticed that as I got close to removing the nut the nut would start to spin in place, even when I held the spur gear and slipper pads down I could not remove it. Anyone have any ideas on how I should go about fixing/removing this? Thanks.
 

Theonlylukas

Well-Known Member
Messages
12
Reaction score
0
Arrma RC's
  1. Fury
The stripped nut is the one on the end
 

Attachments

  • IMG_5820 (1).JPG
    IMG_5820 (1).JPG
    44.4 KB · Views: 32

Dreadstar

Well-Known Member
Messages
293
Reaction score
147
Location
Glasgow,Scotland
Arrma RC's
  1. Fury
That actually looks as if the nut has been put on backwards,with the nylon insert to the inside. It's the nylon section that's holding on,and because it's not threaded,it'll just spin in place. Try pulling the nut off with a pair of pliers,pulling and twisting at the same time and then junk the nut and replace it with a new one.
 

Theonlylukas

Well-Known Member
Messages
12
Reaction score
0
Arrma RC's
  1. Fury
That actually looks as if the nut has been put on backwards,with the nylon insert to the inside. It's the nylon section that's holding on,and because it's not threaded,it'll just spin in place. Try pulling the nut off with a pair of pliers,pulling and twisting at the same time and then junk the nut and replace it with a new one.
Thanks for the quick response
 
Top