Kraton Gap - Servo arm to bellcrank

SaltyLocal

Well-Known Member
Messages
332
Reaction score
176
Hi all,

I have a huge gap between the servo arm and bellcrank (pictured below). It was definitely not like that with the stock servo and bell crank. I upgraded the servo, mount, saver and bellcrank using HR products and unfortunately, I’m now left with this rather large gap. Any suggestions?

D8CD81A1-C0B2-48B4-967A-6D1ED12D8A5E.jpeg


11B48FC8-E929-4647-A106-E75B89666588.jpeg


FB4CF3C5-5425-4EEA-B2E6-2F1CDC2432F4.jpeg
 

RC_Noob

Well-Known Member
Messages
134
Reaction score
118
Location
SoCal
Arrma RC's
  1. Kraton 6s
I had something similar with mine, I just used shims to fill in the gap until it was level.
 

Stokt

Premium Member!
Premium Member
Messages
22
Reaction score
33
Arrma RC's
  1. BigRock 4x4
  2. Kraton 6s
I have the same setup. I cut a piece off the leg of the stock plastic servo mount to the proper length and used that as a shim. Works perfectly.
 

SaltyLocal

Well-Known Member
Messages
332
Reaction score
176
Just seems odd that it’s ok to drive it this way. You’d think it’d lead to issues later. I guess I should’ve researched prior to investing and installing. 🤦🏻‍♂️
I have the same setup. I cut a piece off the leg of the stock plastic servo mount to the proper length and used that as a shim. Works perfectly.
I’ll try that and maybe add a shim to each side. Thanks man!
 
Last edited:
Top