Gearing problems with my fury

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

Sasquatch86

Member
Messages
13
Reaction score
17
Location
Pawnee, il
Arrma RC's
  1. Raider
Hey,
Im having the toughest time getting the gearing right on my fury. I did have 87/22 on it, but realized that was way off. I switched 15/87 and it doesn't seem to run as good as it could! Thanks everyone
 
Normally,when you need to drop a pinion size for heat reasons,you just go down in size by one or two teeth. However,by dropping by seven teeth,you've really slowed down the truck. Originally,with the 22/87 gearing,you were sitting at a ratio of 1:4,now you are nearer 1:6. You would have been better to drop at the most down to a 20t pinion,which would have still given you a reasonable turn of speed.
 
Normally,when you need to drop a pinion size for heat reasons,you just go down in size by one or two teeth. However,by dropping by seven teeth,you've really slowed down the truck. Originally,with the 22/87 gearing,you were sitting at a ratio of 1:4,now you are nearer 1:6. You would have been better to drop at the most down to a 20t pinion,which would have still given you a reasonable turn of speed.
Thanks man, im going to hobby shop right now and try 20t pinion
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top