GoPro Interfering with receiver

[stuartd]

I got a GoPro session 5 and a GoPro Hero 7 recently. I'm using the normal Tactic TTX300 controller. Attached a mount to my Typhon 6s v3 and put the session on, seemed OK but the car stopped responding for a few seconds a couple of times, thankfully it wasn't WoT and no damage done but I found it kinda concerning. Took the session off (well it got launched off onto the grass the second time it ran into a kerb, lol) and everything was back to normal. Because I've never had this issue before with any of my three Arrma's and as removing the camera from the RC fixed it I am putting it down to interference. Just wondered if anyone else has encountered it ?

 

[LibertyMKiii]

The session model does not have GPS, is there any other wireless signals with that model? I cannot imagine any reason whey it would cause an issue. I have an older Hero 5 black and never had an issue.

-Liberty

 

[BLXLyfe]

the session uses Wifi.

 

[LibertyMKiii]

Most WiFi is 2.4 ghz like our RC radios, but modern radios hop frequencies and shouldn't see interference like that.

 

[nino]

Can you turn off the wifi on the session?

 

[BashingBrian]

I use a Hero session 5 and have never had any trouble..?

 

[BLXLyfe]

Can you turn off the wifi on the session?

on mine you could. but its very difficult these days to end up on a busy 2.4 network but it is possible

 

[stuartd]

Yeah, was thinking wifi interference but was just really surprised it happened.

 

[BLXLyfe]

Yeah, was thinking wifi interference but was just really surprised it happened.

Only way is to run it with it turned off and get back to us.