Newer to the hobby. I have however purchased the big rock, senton, typhon and granite. They are all tons of fun. The granite however after just a few runs has started cogging. It appears to be intermittent and am wondering if this is an esc or motor issue. Mesh is set good and the motor rotates as it should with turning it manually. Have a temp gun and neither was getting hot. Any input would be much appreciated, thanks
Granite 3s blx cogging
- Thread starter Dignify
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
links, including eBay, Amazon, and others.
- Messages
- 6,754
- Reaction score
- 12,426
- Location
- ST.LOUIS
- Arrma RC's
- BigRock 4x4
- Mojave
- Notorious
- Senton 6s
- Senton 3s
- Typhon 6s
Smaller pinion gear
Higher volts
Lower kv motor
Smaller ,lighter tires
Check all wires from esc to motor for damage
30$ 3670-2850kv motor is a great mod.
Higher volts
Lower kv motor
Smaller ,lighter tires
Check all wires from esc to motor for damage
30$ 3670-2850kv motor is a great mod.
- Thread starter
- #3
Thanks, I will look into all of that. Took it out and it's only doing it when I first give it throttle. It's going to be my ramping truck so maybe I will start with a smaller pinion, don't need that much top speed for that. Thanks again
