Granite Granite BLX 3S

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

JSwope

Member
Messages
14
Reaction score
5
Arrma RC's
  1. 4x4-Mega
  2. Granite
I went to run my Granite this evening and the truck was making a higher than normal noise or scream than normal. Once the truck got up to speed the truck seemed to run better. Any Ideas on that, has anyone else experienced this sounds. Kind of sounds like the gears are not grabbing.
 
I went to run my Granite this evening and the truck was making a higher than normal noise or scream than normal. Once the truck got up to speed the truck seemed to run better. Any Ideas on that, has anyone else experienced this sounds. Kind of sounds like the gears are not grabbing.
It's called a loose slipper clutch. Stop running it before you burn up the pads and tighten it up ???
 
Loose slipper, you can try to tighten it up. Remove the center shaft, there is 2mm hex head bolt down in the middle of the slipper to loosen or tighten the slipper. You may have to take the slipper apart and add some blue thread lock on the threads if you can't keep the slipper tight.
 

Attachments

  • AR102666 (1)-2.jpg
    AR102666 (1)-2.jpg
    309.3 KB · Views: 46
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top