stephen
Active Member
- Messages
- 51
- Reaction score
- 47
- Arrma RC's
- BigRock 4x4
So my crawler needed some help in the body department. I may likely do this trick to my BRCC as well. If this hack has been done before, credit goes to them as this just came to mind when I tripped over a water bottle. The driver side hole is excessive, but might be able to get some more run time out of it.
Use a soldering tip to start the hole, finish it off with a dremel or round file
Get a socket that fits just inside the inner ridge, and give it a few good hits with a hammer
And there ya go. Add one underneath the body to add some support as well
Use a soldering tip to start the hole, finish it off with a dremel or round file
Get a socket that fits just inside the inner ridge, and give it a few good hits with a hammer
And there ya go. Add one underneath the body to add some support as well