Kraton Help rewiring after new servo install on k6s

[harv666]

Im sorry im new to Aarma and I hate to ask a stupid question but better safe than sorry. Installed a new servo and receiver, do I run the esc and servo cable over the chassis brace or under the drive shaft? I just replaced the chassis brace also so it doesn't have that cable hook anymore but I beleive that was for the battery cable anyway. Could someone send a pic of what it should look like?

Thanks in advance...

 

[Overpowerrc]

Any way it’s safe. If your worried use sims electrical tape as a safety barrier to catch it before to gets too bad

 

[slick2500]

Im sorry im new to Aarma and I hate to ask a stupid question but better safe than sorry. Installed a new servo and receiver, do I run the esc and servo cable over the chassis brace or under the drive shaft? I just replaced the chassis brace also so it doesn't have that cable hook anymore but I beleive that was for the battery cable anyway. Could someone send a pic of what it should look like?

Thanks in advance...

I find over to be easier to do but it doesn't look as clean as going under. If you go over zip tie the wires to the brace.