Typhon Hex pins stuck

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.

BulletRCs_NZ

Very Active Member
Messages
1,031
Reaction score
1,220
Location
Martinborough, New Zealand
Arrma RC's
  1. BigRock 4x4
  2. Senton 3s
  3. Vorteks
I can't get the pin out of the front right wheel hex. I need to change the wheel bearing and I have loosened the grub inside the hub but the pin won't budge even if I give it a wack! I removed the rear wheel, loosened the hub grub screw but that pin won't budge either.

WTF am I doing wrong???

Annoyed kiwi 😡😡😡
 
I can't get the pin out of the front right wheel hex. I need to change the wheel bearing and I have loosened the grub inside the hub but the pin won't budge even if I give it a wack! I removed the rear wheel, loosened the hub grub screw but that pin won't budge either.

WTF am I doing wrong???

Annoyed kiwi 😡😡😡
Arrma may have gotten some threadlock in there, I know this is going to sound like a dumb question but did you try some heat on it?
 
Probably some residual Loctite but I’ve never had trouble driving the pins out with a punch after removing the grub screw. You could try some heat on the pin with a small torch to soften any residual threadlocker
 
Happy kiwi now 🤣😁😁
Excited Merry Christmas GIF by Life of a Potato
lol
 
Old Thread: Hello . There have been no replies in this thread for 90 days.
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.
Back
Top