Dionisi
Member
Im running a senton blx v3 on 6s with a 16 tooth pinion on a set of bandito onroad tires. Getting what i think are some high temp readings but in an unuusal place. The motor is reading around 160 running on flat pavement albeit pretty hard. The esc seems ok at like 110 120 but as continued moving the temp gun (dynamite full size gun) around is soared to 180 near the center diff area. Just touching the front driveshaft for a millisecond nearly singed my finger. So i continue getting closer to the hotzone with my temp gun and pointing directly towards the front center diff area and get a reading of 200+ yikes!
Checked for any bad bearings or binding nothing. Wondering if its normal for the senton. Nothing shut down or failed during the run just seemed a bit too hot. It was around 80 degrees out. Maybe gear down a tooth or two.
Checked for any bad bearings or binding nothing. Wondering if its normal for the senton. Nothing shut down or failed during the run just seemed a bit too hot. It was around 80 degrees out. Maybe gear down a tooth or two.