- Thread starter
- #21
So. It turns out when using these Integy steering components, they don’t allow the axles to e tend far enough out. I’m need another 0.75-1.0 mm, otherwise the nut is too tight against the bearing and won’t let the driveshaft turn freely once assembled.
I could find an internal bearing that’s a bit thinner or ?
For now I’m going to write Integy and see what they think. Everything fits fine with the stock plastic part.
I’ll finish up with the tie rods and pivots for now and report back later!
I could find an internal bearing that’s a bit thinner or ?
For now I’m going to write Integy and see what they think. Everything fits fine with the stock plastic part.
I’ll finish up with the tie rods and pivots for now and report back later!